NS-2 Volume 1

Table of Contents
Introduction
Section 1 - General Requirements
Section 2 - Inspection, Testing & Repair Requirements
Section 3 - Evaluation of Imperfections
Section 4 - Inspection & Repair Procedures
Section 5 - Receipt Inspection Procedures for New Drillpipe
Section 6 - Limited Service
Appendices

Amendments

001 - Hardbanding, Issued 12/05/02, Rev 0, Nov.02
002 - Internal Visual Inspection, Issued13/05/02, Rev 0, Nov.02
003 - Surface Preparation, Issued 20/01/03, Rev 0, Nov. 03
004 - Bit Box Bevel Diameters, Issued 27/01/03, Rev 0, Nov.03
005 - Drillstring Sub Lengths, Issued 27/01/03, Rev 1, Nov.03
006 - Used Tool Joint Dimensional Acceptance Criteria, Issued 12/02/03, Rev 0, Nov.03

Bulletins

Bulletin 001.03, Rev 0, Aug.03

Supplements

Supplement SP001 - Integral Joint Tubing, Rev 1, Oct.2005
Supplement SP002 - Fishing and Milling Tools, Rev 0, Oct.2005
Supplement SP003 - Grant Prideco Prop Tool Joints, Rev 0, Oct.2005

NS-2 Volume 2

Table of Contents
Introduction

Supplements

Supplement SP004 - Adjustable Stabilisers, Rev 0, Oct 2005.
Supplement SP005 - Liner Hanger Running Tools, Rev 0, Oct.2005
Supplement SP006 - Casing and Tubing Crossovers, Rev 0, Oct.2005
Supplement SP007 - Cementing Tools, Rev 0, Sept 2005
Supplement SP008 - DST Tools and DST Circulating Tools, Rev 0, Oct.2005
Supplement SP009 - Inflatable Packers, Rev 0, Oct.2005
Supplement SP010 - PBR Cleanout Tools, Rev 0, Oct.2005
Supplement SP011 Refurbished Bits, Rev 0, Oct.2005
Supplement SP012 - Coring Equipment, Rev 0, Oct.2005
Supplement SP013 - Gravel Pack Running Tools, Rev 0, Oct.2005
Supplement SP014 - PBR Cleanout Tools, Rev 0, Oct.2005
Supplement SP015 - Abandonment Tools, Rev 0, Oct.2005